Use And Characteristics Of The Grinding Machine

This mill throwing machine is a double disc machine, which can be operated by two people at the same time, suitable for pre-grinding, grinding and polishing operation of metallographic samples. The machine through the inverter frequency regulation, can directly obtain the speed between 50~1400 RPM, so that the machine has more extensive application. It is an essential device for users to make metallographic samples. This machine has a cooling device to cool the specimen during pregrinding to prevent damage to the specimen from overheating. The machine is convenient to use and reliable, and it is the ideal sampling equipment for factories, scientific research units and laboratories of colleges and universities.

The Key Technical Indexes

1. Operating Voltage: 220V 50HZ

2. The Diameter Of The Disc Disc: φ230mm (optional 203mm) speed 50-1400 rpm

3. Motor: YSS7124,550W

4. Overall Dimension: 750×700×300mm

5. Weight: 45kg

MPT Mill Throw Head Use

MPT grinding head is a product suitable for the laboratory, which can be used for the preparation of one to three samples. Each sample can be used at different pressures, and the adjustable drip batching device can be selected.

Technical Parameters Of MPT Grinding Head

Power Supply: 220V 50HZ (Note: see the input voltage plate)

Speed: 50 r/min

The Force Applied To Each Sample: 0~40N

Number Of Samples Prepared: 1-6

Net Weight: 15 kg

Installation And Operation Method Of Grinding Machine Head

(1) Fix the bracket and the bracket seat on the base of the grinding machine;

(2) The grinding head placement on the support seat;

(3) Adjust the height, lock the hand fixed;

(4) Lift the afterpress head piece (knob) and put the sample into the holder;

(5) Adjust the sample pressure: adjust the knob to test the pressure on the sample, and tighten the lock handle on the grinding head.

(6) Open the power supply of the machine and the head successively. The head will run with the machine at the speed of 50 r/min for grinding.

(7) It is recommended to grind down every 3 minutes to check the progress of the workpiece surface. When polishing, it can be extended to 5 minutes.